Build your own mega 3D printer
with the imaginbot.com controller
Driving of high power engines
Power requires a bespoke power supply.
Think about what you can do with a great 3D printer With the imaginbot controller you can make the 3D printer you have always dreamed of, large, robust and low cost
The imaginbot card is a controller released under creative commons license by imaginbot.com It is used for the construction of large 3D printers, in our case of 1 cubic meter.
Compatibility at the highest level RepRaps are the most popular 3D printers in the world: use spare parts to your advantage
The “Controller for imaginbot 3D printer” is composed of 2 distinct boards "Controller" tab and "Power supplies" tab. Both units are connected, by means of simple insulated cables, and must work simultaneously.
Is your question not here?
The imaginbot controller card is able to control stepper motors operating in parallel For accuracy 1 on the X axis, 2 on the Y axis and 4 on the Z axis as well as that of the extruder
Each motor is equipped with a dedicated controller, this is not installed on the boards. The solution of mounting external controllers, near their motors, has the undoubted advantage of keeping the spinning lines short and electromagnetic pollution low.
The controller power supplies are drawn from power supplies placed in an external cabinet. This solution also aims to make the system easier to maintain the set of parts that are more installable and scalable, as the bulkier and heavier components are separated.
imaginbot.com disclaims any kind of responsibility deriving from the construction and careless use of the board and all its components and connections. Pay close attention.